Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 41
6.14 – Port Authentication Configuration
6.12 Protected Port Configuration
The Protected Port function allows you to isolate the traffic between protected ports. For
example, if Ports 1, 2 and 3 are marked as protected, the traffic between these three ports
will be blocked, even they are in the same VLAN. However, they still can communicate with
other ports in the same VLAN. This function adds another level of security to the switch.
1. Select Enable.
2. Click Apply in the Protected Function section of the screen.
3. Select the ports that should be isolated from each other and click Apply.
4. If you want to choose all ports, click on Select All. Remove all can be used at a later
time to remove the protection from all of the ports