Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 35
6.7 Port-based VLANs
This switch supports both 802.1Q VLAN and port-based VLAN functions. This screen can
be used to configure port-based VLANs.
There are three sections on the screen:
 The top section is used to choose the VLAN function. Choose between 802.1Q VLAN,
Port-based VLAN or Disabled for the VLAN function.
 The middle section of the screen is used to create and modify a port-based VLAN. Use
the following steps:
1. Select the VLAN ID number.
2. Enter a name for the VLAN.
3. Select the ports for the VLAN. You can use Select All if you want all of the ports
to be included. (Remove All can be used to remove all the ports from the VLAN at
a later time.)
4. Click Apply to save the changes.
 The bottom section is the Port-based VLAN Table. This table displays the port-based
VLANs for the switch.
Figure 6.9 – Port-Based VLAN Settings