Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 33
6.5 Static MAC Address Table
The 2600M also supports static MAC address assignments. Static MAC addresses can be
assigned by two methods:
1. Select from the MAC address list in the Dynamic MAC Address Table.
OR
2. Enter a MAC address and select the port.
3. Add this entry to the Static MAC Address Table by clicking on Add MAC.
The switch will not age out these static MAC addresses. There is a limitation for these
static MAC addresses - they are allowed to work on the assigned port only because they
are static fixed on the assignment port.
If you want to delete an entry in the static MAC address table, click Delete and the static
MAC address will be removed from the table.
Figure 6.7 – Static MAC Address Table
Port Security
You can configure the MAC Security Configuration function for port access security with a
MAC address. The two modes that can be used are:
 Accept mode - Only the static address can access the network via the port.
 Reject mode - Only the static address cannot access network via the port.