Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 31
6.3 Spanning Tree
The spanning tree menu is used to enable/disable the spanning tree function and
configure the bridge parameters. Refer to the section in the CLI chart for detailed
information about spanning tree settings.
Click on Apply to make changes to spanning tree.
Figure 6.4 – Spanning Tree
Once the parameters are set, click on Configuration STA Port and the configuration page
displayed below will appear.
Figure 6.5 – Spanning Tree Parameters
Select a port number from the drop down arrow next to Bridge Port Number to check the
spanning tree status. Click on Apply after making any changes.