Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 26
Command Description Syntax
Use this command to determine the
maximum storm rate setting and the
port list controlling the storm control
trunk Displays trunking configuration show trunk
6.0 Web Management
The 2600M switch can be managed via your web browser. You can use the default IP to
connect to the switch for the first time. The default IP address is 192.168.1.5.
You can also connect to the switch via the console using the CLI commands listed in
Section 5.0. Use the show net command to check the default address of the switch. If you
want to change the IP from the CLI commands, use set net ip xxx.xxx.xxx.xxx netmask
xxx.xxx.xxx.xxx gateway xxx.xxx.xxx.xxx to set the IP for your installation.
The default values for the switch are listed below:
IP Address
192.168.1.5
Subnet Mask
255.255.255.0
Username
admin
Password
123456
Table 6.1
Access your web browser, and type in http://192.168.1.5
(or the assigned IP address) in
the address field. The login screen will be displayed. (see Table 5-1) requesting the
username and password for login authentication. The default username is admin and
password 123456. Click on the Login button. The login process now is completed.
The management home page will be displayed.
Figure 6.1 – Management Home Page