Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 25
Command Description Syntax
guest Displays name and password for
guest
show guest
gvrp Displays GVRP protocol setting show gvrp
http Displays http protocol setting
If disabled, the web management
interface for the switch will be off.
show http
idle Displays idle time for console logout
If there is no keystroke during the
amount of time set, the console and
telnet interface will logout
automatically.
show idle
igmp Displays igmp snooping function and
the IP multicast groups that have
been learned by the switch
show igmp
loopback Displays loopback detection setting
The loopback function can detect
packet loopback problems from a
port. If a loopback is detected, the
port will be disabled.
show loopback
mirror Displays mirror function configuration show mirror
net Displays current IP address
If DHCP is enabled, this command
will show the IP address received
from the DHCP server.
show net
port Displays status and configuration for
each port
show port
protect Displays protected port setting
Protected ports are ports that cannot
communicate with each other
show protect
pvlan Displays port based VLAN
configuration
show pvlan
qos Displays QoS configuration for all
ports
show qos
ratecontrol Displays rate control setting for each
port
show ratecontrol
rmon Displays RMON configuration show rmon
security Displays port security mode for static
MAC address
show security
snmp Displays snmp configuration
The Security Control could be No,
Accept, or Reject modes. No is for
no MAC address security. Accept is
used for the static MAC addresses
that can be accessed. Reject is used
for the static MAC addresses that
cannot be accessed.
show snmp
sta Displays spanning tree setting show sta
stormcontrol Displays current packet storm control
configuration
show stormcontrol