Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 23
Command Description Syntax
Same as the exit command.
Show subcommand list:
? Help commands
show ?
help Help command
show help
1qvlan Displays 802.1q VLAN configuration Example: show 1qvlan [status
|static|table|port]
status: show 802.1q, ingress
filter and GVRP protocol status
static: show static vlan table
content
table: show all vlan table content
port: show the pvid and Priority
for tag of ports
Example: show 1qvlan status
will display:
802.1Q VLAN: Enable
Ingress Filter: Enable
VLAN Mode : SVL
age Displays current aging time
show age
arl Displays ARL table
Example:
>show arl dynamic
[
Dynamic Address Learning Table]
Item Port Mac Address VID
1) CPU 00-00-01-64-64-64 1(0x001)
2) 8 00-00-e2-82-8c-e6 1(0x001)
3) 4 00-20-14-95-0a-32 1(0x001)
show arl [static|dynamic]
static: shows static MAC
address set in ARL table
dynamic: shows dynamic
MAC address learned in ARL
table
automode Displays automode will show current
setting for port configuration (either
Auto Negotiation or Auto Detect)
For Auto Negotiation mode, the
switch will do auto-negotiation
ON/OFF when the auto mode of port
is enabled/disabled. Auto-MDIX
function will be disabled when the
auto-negotiation function of port is
OFF.
For Auto Detect mode, the switch
will always keep auto-negotiation
function ON but jmodify its attribution
if the auto mode of port is disabled.
The Auto-MDIX function will be
always enabled in this mode.
For applications, you should select
Auto Detect mode if the connected
device is auto-negotiation enabled.
You can select Auto Negotiation
mode if the connected device is auto-
show automode