Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 19
Command Description Syntax
Mac Address Table” in web interface.
The table will show the learned Mac
addresses and you just need to select
from the learned address list and add
it to static address table.
Additional Information:
The MAC
address filter-in function requires two
conditions.
The port security mode is set to
“Accept”.
Static MAC address is assigned on
Port (for example, MAC 1 on Port 1).
In this case, only MAC 1 can access
network through Port 1. But there is
also a limitation for MAC 1 - it can
access network through Port 1 only
because it is a static fixed address on
Port 1.
mode 1 = Accept function
mode 2 = Reject function
For examples, “set security 1 1”
will set Port 1 to accept the users
with the static MAC addresses
configured on Port 1.
rmon Set RMON function configuration set rmon [1|0] <1=enable,
0=disable>
snmp Set snmp configuration
Use this command to configure the
following items for SNMP operation.
 Name of the switch with “name”
sub-command.
 Location of the switch with
“location” sub-command.
 Contact for the switch with
“contact” sub-command.
 GET Community string with
“getcommunity” sub-command
 SET Community string with
“setcommunity” sub-command.
 TRAP Community string with
“trapcommunity” sub-command.
 TRAP IP Address with “tapip”
sub-command.
 Test TRAP Operation with “txtrp”
sub-command
set snmp [ ]
name -set system name
location - set system location
contact - set system contact
name
getcommunity -set GET
community
setcommunity -set SET
community
trapcommunity - et TRAP
community
trapip - set TRAP IP address
txtrap -send Trap for test
sta Set spanning tree configuration
Additional information:
 priority (0~65535): Bridge
priority is use to select the root
device, root port and designated
port. The device with the highest
priority (lowest value) becomes
the STA root device. If all
devices have the same priority,
the device with the lowest MAC
address will then become the root
device.
set sta
help or ? – help commands
enable – enable spanning tree
disable – disable spanning tree
bridge – set spanning tree bridge
configuration
port – set spanning tree port
configuration
Syntax for set sta bridge:
>set sta bridge
priority - set bridge priority.
hello - set bridge hello time