Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 15
Command Description Syntax
idle Set idle time for console
Default is 10 minutes
set idle [time]
30~3600 seconds
igmp Set IGMP configuration set igmp [enable or disable}
loopback Set loopback detection of port
Enable loopback detection on port
Disable loopback detection on port
Release ports that loopback detected
set loopback
[enable|disable|release]
mirror Set mirror configuration
set mirror ingress div x : every x
packets, capture one for mirror. For
example, “set mirror ingress div 10”
will capture one packet from every ten
packets from ingress traffic.
set mirror ingress mode xx : mirror
all packets or mirror packets with
some DA or SA only. For example,
“set mirror ingress mode all” will
mirror all packets.
set mirror ingress mac xx-xx-xx-xx-
xx-xx : if the mirror mode is for the
packets with some DA/SA, users can
assign the DA/SA with this command.
set mirror ingress monitor xx,xx,xx
:set the monitored ports. For
example, “set mirror ingress monitor
1, 2, 5” will mirror the ingress traffic
from port 1, 2 and 5. (Note: If the
monitored traffic exceeds the
maximum bandwidth of the capture
port, flow control function will work on
these monitored ports.)
set mirror egress command
This command is used to configure
the mirror operation for egress traffic.
Its syntax is similar to the mirror
operation for ingress traffic. Please
refer to “set mirror ingress command”.
set mirror port command
This command is used to set the
capture port for mirror operation. For
example, “set mirror port 3” will
capture the mirror traffic to Port 3.
set mirror ? (or set mirror help)
will display sub commands for
mirror
set mirror enable
set mirror disable
set mirror ingress
div - Set mirror ingress/egress
[div=%d]
mode - Set mirror ingress/egress
[mode=ALL/SA/DA]
mac - Set mirror ingress/egress
[mac=xx-xx-xx-xx-xx-xx]
monitor - Set mirror
ingress/egress [monitor=xx,xx,xx]
set mirror ingress
net Set network IP configuration
This command is used to configure IP
settings for the switch.
This switch supports static IP setting
or dynamic DHCP IP assignment. If
DHCP function is enabled, the switch
will try to obtain the IP configuration
from the DHCP server. If a DHCP
server is not found, the switch will use
its default IP configuration. You can
set net
[dhcp]
[ip]
[netmask]
[gateway]