Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 11
The following table lists the CLI commands and descriptions.
Command Description Syntax
Help Commands (use ? to display Help Commands)
help Help commands
set Set commands
show Show commands
default Restore to factory default setting
del Del commands
find Find commands
whoami Display current login user name
reset Reset system
ping Ping a specified host with IP address
backup Backup run-time firmware of
configuration
Upgrade Upgrade run-time firmware or
configuration file
exit Logout
logout Logout
Set Command (enter Set at the prompt to use the sub commands listed below)
help Help commands
? Help commands
1qvlan Set 802.1q VLAN configuration
 enable
 disable
 ingressfilter - Set ingress filter
enable or disable
 create - create new 802.1q VLAN
with specified VLAN ID and VLAN
name
 modify - Modify the setting of a
802.1q VLAN
 pvid – Set the port VLAN ID of
the specified port
 mgrpvid – set the port VLAN ID
of the management port
 priority – set the priority for tag of
specified port
 mode – set the VLAN mode
Set 1qvlan
Additional information:
The enable and disable sub-commands are used to enable/disable 802.1Q VLAN function
of the switch.
The ingressfilter sub-command is used to enable/disable VLAN filtering executed at
ingress port.
Enable: The VLAN filtering function will be executed when a packet is received at the
ingress port. If the ingress port is in the same VLAN of the received packet, this packet will
go to forwarding stage. Otherwise, the packet will be discarded by VLAN filtering at ingress
port.