Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 10
8. The initialization screen will look similar to this example:
Figure 5.1 – Boot up screen
Logging into the Switch
1. Press Enter.
2. Enter the username and password. The default username is admin and the default
password is 123456.
3. After logging into the switch, a prompt will be displayed. You can use the help or ? to
display a list of commands.
Booting Program Version 1.05.00, built at 14:44:03, Jul 29 2005
RAM: 0x00000000-0x00800000, 0x0000cc78-0x007f3000 available
FLASH: 0x05800000 - 0x05900000, 16 blocks of 0x00010000 bytes each.
==> enter ^C to abort booting within 3 seconds
Start to run system initialization task
[System Configuration]
Company Name :
Model Name : Intelligent Switch
MAC Address : 00:00:01:23:45:67
Firmware Version: 3.02.02 < Mar 13 2006 15:13:36 >
Press <ENTER> key to start.
UCD-SNMP version 4.1.2