Specifications

Waters Network Systems 2800M/MR User’s Manual Page 16
4.2 Configuring IP, Subnet Mask and Default Gateway
The default settings for your switch are listed in the following table:
Default Value
GSM2800M/MR
IP Address
192.168.1.1
Subnet
255.255.255.0
Default Gateway
192.168.1.254
Table 4-1
You may either change the IP address of the switch or change the IP address of your
workstation. To change the IP address of the switch, via the console connection, you will have
to use the CLI command listed below. A complete list of CLI commands is in Section 6.0 of this
manual.
1. Once you have logged into the switch, you will see the following screen.
Figure 4.1 – Login screen
4.3 Configuring the Switch via the Web
You can configure and monitor the switch through:
 CLI
 Web browser
 SNMP manager. The user interface for SNMP is not covered at this time.
Figure 4.2 – Ethernet Port Connection
Assign an IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway = 192.168.1.254
Ethernet LAN