Specifications

Waters Network Systems User’s Manual Page 47
PSX/MS1008-TX
Forward Delay
time
You can change forward delay time, which is the number of
seconds a port waits before changing from its Spanning-Tree
Protocol learning and listening states to the forwarding state.
Enter a number 4 through 30.
The following parameters can be configured on each port. Click the Apply button
to modify.
The following table describes the path cost and port priority.
Parameter Description
Port Priority You can make a port more or less likely to become the root
port. The range is 0-255, and the default setting is 128.
Path Cost Specifies the path cost of the port that switch uses to
determine which ports are the forwarding ports. The lowest
number of forwarding ports is 1, and the range is 1-65535.
The default value is base don IEEE802.1D.
10Mbps = 50-600 100Mbps = 10-60
If you change the value, you must reboot the switch.