Specifications

Waters Network Systems GSM2109/GSM1009-SFP User’s Manual Page 19
4.2 CLI Commands
To use the CLI commands, enter enable once you have logged into the switch.
The following table lists the Command level of the CLI commands.
Command Description Prompt Access
Method
Exit
Method
User EXEC This command is a subset of
the commands available at
the privileged level. Use
this command to:
 Perform basic tests
 Display system
information
switch> Begin a
session with
the switch
Logout or
quit
Privileged
EXEC
The privileged command is in
advanced mode. Use this
command to:
 Display advanced status
functions
 Save configuration
switch# Enter the
enable
command
while in EXEC
mode.
Enable takes
you into the
privileged
mode.
Disable
Global
configuration
Use this command to
configure parameters that
will apply to the switch as a
whole
switch
(config)
#
Enter the
configure
command
while in
privileged
mode
Exit or
end
VLAN
database
Use this command to
configure VLAN specific
parameters
switch
(vlan)#
Enter the
VLAN
database
command
while in
privileged
EXEC mode
Exit
Interface
configuration
Use this mode to configure
parameters
switch
(config-i
Enter the
interface
Exit