Specifications

Waters Network Systems GSM2109/GSM1009-SFP User’s Manual Page 18
5. Once you have logged into the system, the following command prompt will be
displayed. Enter enable to access CLI commands.
Figure 4.3 – CLI and Telnet Command Prompt
Switch management can be accessed via the following methods:
• Console Connection described above. Begin entering CLI commands at this
prompt.
• Telnet – use the default IP of the switch 192.168.16.1 to access switch
management via Telnet.
• Web Interface described in Section 5.0.
Note: A complete list of CLI commands is included in this section.