Specifications

Waters Network Systems GSM2109-1009-8PoE User’s Manual Page 99
Command Level Description Example
event smtp
[Link-UP|Link-
Down|Both]
I Set port event for SMTP switch(config)#interface
fastethernet 3
switch(config-if)#event smtp
both
show event P Display event selection switch#show event
no event
device-cold- start
G Disable cold start event type switch(config)#no event
device-cold-start
no event
authentication-
failure
G Disable authentication failure
event type
switch(config)#no event
authentication-failure
no event X -
-ring-topology-
change
G Disable X- ring topology event switch(config)#no event X -
-ring-topology-change
no event
systemlog
I Disable port event for system log switch(config)#interface
fastethernet 3
switch(config-if)#no event
systemlog
no event smpt I Disable port event for SMTP switch(config)#interface
fastethernet 3
switch(config-if)#no event smtp
show systemlog P Display system log client &
server information
switch#show systemlog
The following table lists the SNTP Commands.
Command Level Description Example
sntp enable G Enable SNTP function switch(config)#sntp enable
sntp daylight G Enable daylight savings time. If
SNTP function is disabled, this
command can’t be applied.
switch(config)#sntp daylight
sntp
daylight-period
[Start time] [End
time]
G Set period of daylight savings
time. If SNTP function is
disabled, this command can’t be
applied.
Parameter format:
[yyyymmdd-hh:mm]
switch(config)# sntp
daylight-period
20060101-01:01
20060202-01-01
sntp
daylight-offset
[Minute]
G Set offset of daylight saving time.
If SNTP function is disabled, this
command can’t be applied.
switch(config)#sntp
daylight-offset 3
sntp ip
[IP]
G Set SNTP server IP. If SNTP
function is disabled, this
command can’t be applied.
switch(config)#sntp ip
192.169.1.1
sntp timezone
[Timezone]
G Set timezone index, use the
show sntp timzezone command
switch(config)#sntp timezone
22