Specifications

Waters Network Systems User’s Manual Page 15
GSM-2108/GSM-1008SFP
Once you have set the IP address of the switch, you must save the configuration. The CLI
command is: save start.
A detailed list of CLI commands can be found in Section 6.0.
4.3 Configuring the Switch via the Web
You can configure and monitor the switch through:
 CLI
 Web browser
 SNMP manager. The user interface for SNMP is not covered at this time.
Before you are able to communicate with the switch, you must know
the IP address of the switch. Once you know the IP address, follow
these instructions:
1. Connect the switch with a UTP cable to your workstations.
Note: If the workstation connects to the switch, you will have to
setup the same subnet mask between them.
2. Access your web browser or use the console connection.
Note: If you make changes to the configuration, you must save the configuration before
rebooting the switch.
Assign an IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
Default Gateway
=
192.168.
1
.
254
Figure 4.2 – Front View
Ethernet LAN