Owner`s manual

12 13

STEP 1

Lay the rails on the floor and connect the rear spacer using the female

JCN nuts and the Allen key provided.

STEP 2

Place the seat assembly between the rails with the indent facing towards

the rear spacer. The larger vertically mounted wheels (the load wheels)

should sit on the plastic extrusions on the top of the rail. The smaller

horizontal wheels below the seat (the guide wheels) should sit between

the rails. It may be necessary to separate the rails slightly to allow the

guide wheels to fit down between the rails.

Rear Spacer

Female JCN Allen Key

The black extrusions are positioned on the inside.

Insert the JCN Nuts and JCB Bolts attaching the tank to the rails at

locations A & B. The nuts should be placed on the inside and the bolts

on the outside.

STEP 3

Place the tank assembly between the rails.

STEP 4

JCN Nut

(x4)

JCB Bolt

(x4)