Quick Start Guide

QUICK START GUIDE

Model

WP-300

Prepare the Reservoir:

Remove the reservoir from

base and fill with lukewarm

water.

Replace the reservoir onto the

base, PRESSING DOWN FIRMLY

to ensure full seating.

Fill

Replace

When tip is properly

inserted there should be

no gap between handle

and colored tip ring.

Select and Insert Tip:

Prior to Very First Use of Unit, Prime

Unit:

Set pressure control dial on base to

high, point the handle and tip into sink.

Turn unit ON until water flows from the

tip. Turn unit OFF.

Prime Unit (First Time Use Only):

Adjust Pressure Control:

For first time users, adjust pressure

control to lowest position. Gradually

increase pressure to your liking.

Press tip

firmly into

handle.

Insert

High

Gap

This device is compatible with global voltages of 100 - 240VAC, 60/50Hz.

Low

continued on back

PAGE 1
Model WP-300 QUICK START GUIDE 1 2 Prepare the Reservoir: Select and Insert Tip: Press tip firmly into handle. Remove the reservoir from base and fill with lukewarm water. Fill NO Gap Replace Insert Replace the reservoir onto the base, PRESSING DOWN FIRMLY to ensure full seating. 3 O 1 When tip is properly inserted there should be no gap between handle and colored tip ring.
PAGE 2
5 Using your Waterpik® Water Flosser: Aim the water stream just above the gumline at a 90 degree angle. Always place tip in mouth before turning unit on. Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. Turn unit ON. Starting with the back teeth, follow the gumline and pause briefly between teeth. ON O O I 1 2 3 1 2 3 6 Continue until all areas around and between teeth have been cleaned. Turn unit OFF.