Manual
7
Process:
• Place the Grommet in the hole.
Grommet
Items Needed:
Grommet (Qty: 1)
OPTION 1 - MOUNTING CABINET
Process:
Note: Option 1 is for hanging cabinet on trackwall.
If hanging cabinet directly on wall, go to Option 2.
• With assistance hook Mounting Bracket over trackwall
and slide down into place.
Note: Unit cannot be placed over a Joiner Section of track-
wall. Unit must be hung either left or right of the Joiner and
then slid over the joiner.
Hook over Trackwall and
slide down into place
Figure 9
Attach spacer block
to back of cabinet
Note: Spacer block should be located as close to the
center of the cabinet as possible above the bottom edge
in the back of the cabinet.
• Peel paper backing from Spacer Block attach to the
back of the cabinet near the bottom to hold cabinet
level.
OPTION 2 - MOUNTING CABINET
Process:
• Align Wall Cabinet with studs.
• Mark and drill (2) 1/8-in pilot holes. Note Use outside
holes for mounting to studs on 24" centers. Use inside
set of holes for mounting to studs on 16" centers.
• Attach Wall Cabinet to studs using appropriate hardware
as dened by your local building code.
24-in centers
Items Needed:
Mounting hardware as dened by your local building
code.
Figure 9.1
16-in centers
Figure 8