Owner`s manual

Spectra Series Owner’s Manual

Cool

Push and release the MODE button until the display reads COOL

and shows the

symbol. Your system is now in the cooling mode.

To review the cooling set point, momentarily press either the

or button and you will see your current set point displayed along

with the symbol.

To adjust the set point, press and hold either the or button

until the defined temperature is displayed. Note: As the cooling set

point is adjusted, the word COOL will be displayed.

The symbol will flash when the system is operating in the

cooling mode. The cooling cycle starts with the fan and compressor

on.

At the end of the cooling cycle, the fan will remain on for approxi-

mately 30 seconds, unless continuous fan has been selected.

Auto

Push and release the MODE button until the display reads AUTO,

and shows both the

and symbols. Your system is now in the

automatic mode, with either heating or cooling operation available.

To review the heating and cooling set point, momentarily press

either the

or button. The thermostat will then either display

the current heating set point and the

symbol, or the current cooling

set point and the

symbol. If the heating set point and the

symbol are displayed, pressing the MODE button within 5 seconds will

display the cooling set point and

symbol. If the cooling set point

and

symbol are displayed, pressing the MODE button within 5

seconds will display the heating set point and

symbol.

To adjust the heating set point, press and hold either the

or button while reviewing the heating set point.

Note: As the heating set point is adjusted, the word HEAT will be

displayed.

To adjust the cooling set point, press and hold either the

button while reviewing the cooling set point.

Note: As the cooling set point is adjusted, the word COOL will be

displayed.