Owner`s manual

5
Spectra Series Owner’s Manual
Operating Procedures…
To enjoy all the benefits of your Spectra geothermal system, please
review the following operating procedures, service tips and informa-
tion. You’ll find your system easy to operate and simple to maintain at
its peak performance. However, if you have any questions or prob-
lems, contact your local independent WaterFurnace dealer.
What do I need to
know about my
thermostat?
Your digital thermostat has been
designed to provide highly accurate
control of room temperature. In addition,
it will display information relating to your
system’s operation. The clearly marked
buttons and informative display make it
easy to understand and simple to operate.
Note: Your Spectra series geothermal unit will work with almost any
24 VAC thermostat on the market. For obvious reasons, we cannot
highlight the features of all the thermostats. The instructions that follow
apply only to the type of thermostat pictured here. For operating
instructions of other thermostats, contact your WaterFurnace dealer.
General information...
The thermostat normally displays room temperature, mode of
operation selected and current system status. The six buttons on the
front allow complete control of the system.
You may select different heating and cooling set points for the
system to maintain, e.g. 70
o
F in heating and 75
o
F in cooling. Raising
and lowering the set points in heating or cooling is as simple as
pushing a button. In addition you may choose
o
F or
o
C for the display
by pushing the
and buttons simultaneously. Repeating the
process will revert to the original display.
Important: Always allow the system at least 5 minutes to respond to
any changes in settings. The thermostat has been programmed to start
the heating or cooling cycle in stages.
Note: The electronic thermostat cannot be set closer than
2
o
between heating and cooling.