Instructions / Assembly

Press
Press
Pull
4
Installation Tips
How to Use the Quick-Connect Fittings
To connect:
1. There is an existing mark (Figure 1)
at the end of the tubing that you can
use to conrm whether the tubing
is fully inserted into the tting. Push
the tubing into the tting until you
reach the mark on the tubing.
2. If the tubing is not fully inserted, it
will cause leakage. When the tubing
is fully inserted, put the blue lock clip
on the tting. It will lock the tubing in
place and prevent it from falling off.
3. If the tubing is too long, cut it to a
suitable length using a sharp utility
knife or pair of scissors. Cut the
tubing squarely and cleanly (Figure
2). Make sure the tubing is fully
inserted.
To disconnect:
1. Remove the blue lock clip from the
tting.
2. Use your thumb and index nger
to press down on the lock sleeve.
Use your other hand to pull out the
tubing from the tting (Figure 3).
NOTE: Please do not pull out the
tubing directly, or else it will damage
the tting and cause leakage.
Figure 2
Figure 1
Figure 3
Mark for
Full Insert
Cut Cleanly
and Squarely
How to Drill a Hole into Your Sink or Countertop (Optional)
NOTE:
• Please conrm if there is an existing hole available to install the faucet. If not,
please drill a hole in accordance with the following steps.
• If the countertop is thicker than 2.95 inches, the faucet cannot be installed. It’s
highly recommended to watch the YouTube video “How to Drill Faucet Holes”
for a better understanding of the process. There is also a sticker for your
reference when you drill the hole. Remember to wear safety glasses to protect
your eyes while drilling the faucet hole.