Instructions / Assembly

After resetting the lter, turn on the faucet and ush the system for 20 minutes until

the water eventually turns clear.

NOTE: If you need to replace the lter when the life has not expired, press the

reset button for 3 seconds. The lter indicator light will ash. Then press the button

for 3 seconds again. The timer will reset. The lter reset is complete.

Warning:

• Do not store the system in a location exposed to direct sunlight, as this may

cause the aging of the product parts. Do not store or expose the system to an

area below 32°F.

• Do not store the system near appliances with strong magnets, which can cause

re, product damage, or circuit malfunction. Wet or dusty areas may cause

circuit damage.

• Do not place heavy objects on the system.

• Do not allow young children to operate, touch, or climb on the system.

• To prevent the system from breaking when you unplug it, do not pull the power

cord directly. Keep the power plug clean and do not plug or unplug the system

with wet hands. Do not use a step-up transformer to connect to the power plug.

• Do not place ammable or volatile substances near the system.

• Do not place the system near heat sources or re.

Precautions

5. After replacing the lter, press the power button for 3

seconds. The indicator light will be on and you will hear a

“ding” sound. (Note: The system will automatically ush

for 25 seconds, and the reset button and power button will

ash alternately. 25 seconds later, these two buttons will

be on.) After ushing, press the reset button for 3 seconds.

Release it when you hear a “ding” sound. The indicator light

will change from ashing to constant.

6. Put back the front cover and press the button to

lock it. The lter reset is complete.

Caution:

• Do not crush, fold, knot, or damage the power cord.

• When the inlet water does not meet municipal tap water standards (including

large amounts of sediment, excessive oxygen in the water, etc.), a pre-

treatment device should be installed before the installation of this system.

• The feed water pressure of this system is 14.5-87 psi. If the water pressure is