User Guide

quick setup guide

pure water dispenser

SERIES

Read all directions before plugging

in dispenser.

IMPORTANT: Do not plug in dispenser until step 5.

This guide is a general reference to help you quickly

and easily set up your Pure Water Dispenser

200k

Series. For complete setup, operating and safety

instructions, reference the owner’s manual.

Prime water system.

Depress hot water lever to fill the

hot tank until water flows

continuously. This may take about

1 minute. Repeat steps for cold

tank. The cold tank may take

about 3 minutes.

Activate heating

function.

IMPORTANT: Ensure priming

of the hot water system is

complete before proceeding.

Turn on hot tank heater

switch located on rear of

dispenser. Optimum water

temperature will be reached

after several hours.

To learn more, visit water.com

Place dispenser on level floor

surface at least 4 inches from wall.

Insert bottle on dispenser.

Remove tamper-evident seal from plastic bottle

cap. (Do NOT remove plastic cap if using a

NO-SPILL water bottle.) Load water bottle by lifting

and inserting it onto the probe. Be sure bottle is

fully aligned with dispenser, centered over the

probe and fingers or other body parts are clear of

underside of bottle. Apply slight pressure until plug

pushes in and bottle is securely seated. Water will

flow into the tank causing air bubbles.

Plug in dispenser to a GFCI outlet.

Install base plates.

Align side plate with base and slide into base until in

locked position. Repeat for second slide plate.