Instructions / Assembly

ELECTRICAL CONNECTION

ELECTROCUTION HAZARD. FIRST DISCONNECT ALL

ELECTRICAL POWER BEFORE SERVICING.

ELECTROCUTION HAZARD. THE WWDPC MUST BE

ELECTRICALLY GROUNDED.

NOTE: The WWDPC will operate on 115 VAC & 230 VAC systems. Its ambient air

temperature rating is 122°F / 50°C.

1. Disconnect power and verify with a volt meter.

2. Determine the pump electrical requirements. If unknown, contact the pump

manufacturer.

3. Select the appropriate wire gauge per local codes and the pump manufacturer’s

recommendation.

INSTALLATION INSTRUCTIONS

Unit is Recommended to be Installed by a Qualified Professional

PLUMBING CONNECTION (1/4" NPT FEMALE SYSTEM CONNECTION)

1. Select a location for the WWDPC. The WWDPC should be mounted near the

pressure tank or pump, depending upon the installation

LOCATE THE WWDPC FOLLOWING ALL LOCAL CODES. DO NOT

LOCATE THE UNIT WHERE IT CAN BE AFFECTED BY FLOODING.

2. You may assemble the WWDPC to a “Tank Tee” or “Tank Cross” (Figure 1) or adapt

the unit to an in-line pipe fitting (Figure 2). Use Teflon sealing tape or pipe sealant.

Tighten the WWDPC using the wrench flats provided on the bottom connection. DO

NOT EXCEED 15LB./FT. of torque.

Note: Do not allow pipe sealant or other contaminants to enter the small port in the

WWDPC connection.

Note: A mechanical pressure gauge is not required. Use the appropriate plug to block

any unused ports.

Drain

Valve

Relief Valve

1/4" NPT Female

System Connection

INSTALLATION ON TYPICAL TANK TEE

Fig. 1

Pipe Nipple Plug

WWDPC

GENERAL IN-LINE INSTALLATION

Tee

Adapt as necessary

Pipe Nipple

Relief Valve

WWDPC

Fig. 2

1/4" NPT Female

System Connection