Full Product Manual

Inserting Wheels and Brushes in the Vacuum Head
Your Pool Blaster has been configured with wheels and
brushes at the factory in a manner which we have found
perform best in most swimming pool applications.
Should you wish to experiment with different configurations
you can refit the head with just wheels or just brushes with
the Front Wheel.
NOTE: Inserting the wheels into the vacuum head may
require a good deal of force. If you have trouble, you may
find it easier to insert them by placing the wheel on a hard
surface and pushing down on the head.
CAUTION: Wheels OR Brushes with Front Wheel
must be installed prior to use. Water Tech is NOT
responsible for damages to your pool if neither the
wheels nor brushes with Front Wheel are installed in
the vacuum head before use.
Inserting the Filter Bag and Nose Cap
• Place the Pool Blaster on its end on a stable and
secure surface.
• Place the filter bag/seal ring (part no.PBW022AP)
into the Pool Blaster, as shown in diagram. Make
sure the rubber seal ring sits on the funnel. All of
the filter bag must be inside the funnel to ensure
the head closes fully.
• Close the latch squeezing the filter bag/seal ring
in between.
• Never use the Pool Blaster without the filter bag
properly installed. This will damage the impeller
and void the warranty
NOTE: You should not need to apply excessive force in
order to close the latch. If you have trouble, make sure the
filter bag is not between the seal and the nose cap or fun-
nel and there are no other obstructions such as sand.
SETTING UP YOUR POOL BLASTER FOR USE
PREPARING THE VACUUM HEAD /
INSERTING THE FILTER BAG
Vac Head
with Wheels
only
Vac Head
with Brushes
and Front
Wheel only
Vac Head with Wheels
and Brushes as provided
with you Pool Blaster
7