Full Product Manual

Charging the Battery Pack
PRECAUTIONS:
• Make sure power supply is normal household
voltage, 120 volts, 60 Hz
(240 volts, 50Hz International), AC only.
• Do not handle Pool Blaster while charging with
wet hands or without shoes.
• Do not use or store your charger outdoors.
Charge battery indoors in a clean dry place. For
best results, your Pool Blaster battery should be
charged in a location where the temperature is
above 50
o
F and below 100
o
F.
• Only use the charger supplied to recharge this
vacuum. Do not use the supplied charger with
any other appliance or damage may occur.
• Disconnect Pool Blaster from power charger
when not in use.
• Unplug the charger from outlet before any rou-
tine cleaning or maintenance.
• The use of extension cords is not recommended.
Plug the charger into a properly grounded stan
-
dard electrical outlet (120v/60Hz US, 240 volts,
50Hz International) only.
• To protect against risk of electrical shock, do not
put unit charger in water or other liquid.
• To avoid damage to the charger and cord,
never carry the charger by the cord or yank to
disconnect from an outlet. Instead, firmly grasp
the charger body and pull to disconnect. Do
not pull cord around sharp edges or corners.
• Do not allow the cord to hang over the edge of
a table or counter or touch hot surfaces. The
vacuum should be placed or mounted away
from such hot surfaces.
Charging The Battery Pack For The First Time
Only charge the Pool Blaster with the charger
provided with the unit. The charger provided is
specially designed for the Pool Blaster.
Please note that the Battery Pack for your Pool
Blaster has been shipped in a low voltage condition.
You must charge the Pool Blaster Battery Pack
for 12 Hours Before Initial Use
TO RECHARGE THE CLEANER
1.Turn the knob counterclockwise to remove the On-Off
Knob. This will expose the charging jack connection.
NOTE: When removing the On/Off knob it is normal to
hear air escaping. The air inside has simply expanded
from being heated by the motor.
2. Connect the lead plug from the charger to the charging
jack on the Pool Blaster.
3. Connect the charger to the appropriate electrical outlet.
The Pool Blaster should be re-charged for 10 - 12 hours.
4. After charging, ensure that the On-Off knob is fully
secure and turned to the “On” position before attempt-
ing to use your Pool Blaster.
5. The ON-OFF knob should remain disconnected from the
unit and left hanging form the attached lanyard until the
unit is ready to be used.
Do Not leave the unit plugged into the charger for more
than 24 hours.
CAUTION: Replace the ON-OFF knob tightly before plac-
ing the Pool Blaster in water. Placing the Pool Blaster in
water without tightening the ON-OFF knob so that the unit
is “ON” will void your warranty.
BATTERY LIFE
• Your battery pack should give you many hours
of use. If the motor, batteries or charger stop
working, please review the warranty information
and/or read the Commonly Asked Questions.
• The batteries are factory sealed in the motor box,
and CANNOT BE REPLACED. Do not attempt in
any way to destroy or disassemble the motor box
or any of its components. Under no circumstanc
-
es should you attempt to open the battery pack
and replace the batteries yourself.
SETTING UP YOUR POOL BLASTER FOR USE CHARGING YOUR CLEANER
6