Full Product Manual

CONGRATULATIONS on your purchase of a top-quality Water Tech

product which has been thoroughly tested to meet our exacting

quality control standards.

The Pool Blaster vacuum is powered by Nickel-Metal Hydride bat

teries. These batteries will operate at their peak after the second

or third charge. A precise amount of space is left open in the Pool

Blaster body to properly ventilate and cool the batteries, seals and

drive system.

Please take care to tighten the On/Off knob when turning the unit

on and before you submerge the unit in water to prevent any water

from entering the motor box. From time to time, water may enter

the motor box. To drain any water that may enter the motor box,

allow all the water to drain from the exterior vacuum area than re-

move the On-Off Knob and turn the machine so the knob is towards

the ﬂoor and tilt side to side in all directions. The amount of water

may be very small or not noticed at all.

If water has entered the motor box area use a blow dryer on warm

setting to dry any moisture build-up on the inside of the motor box.

Water entering the Pool Blaster body presents no safety hazard and

should be drained occasionally to avoid any chance of long-term

corrosion. The batteries and motor in the Pool Blaster are long lasting

and proper care will help to prolong the life of your appliance.

These guidelines and safeguards help insure that your new Pool

Blaster operates effectively. Please read all instructions carefully be

fore using your Pool Blaster. Please take a few moments to review the

following IMPORTANT INFORMATION before using this tool.

Before Initial Use