Troubleshooting guide

Time of day should only need to be set after extended power outages or when daylight saving time begins

or ends. If an extended power outage occurs, the time of day will flash on and off indicating that the time

should be reset.

STEP 1 – Press

SET CLOCK.

STEP 2 – CURRENT TIME (HOUR): Set the hour of the day using + or — buttons.

AM/PM toggles after 12. Press

NEXT to go to step 3.

STEP 3 – CURRENT TIME (MINUTES): Set the minutes using + or — buttons. If it is desired to

back up to the previous step press

REGEN button once. Pressing NEXT will exit SET CLOCK

and return to the general operating display (page 10).

1. Set time of day:

NOTE: The manufacturer has preset the unit so that the gallons between regenerations will be

automatically calculated after the hardness is entered.

STEP 1 – Press

NEXT and + simultaneously for 3 seconds.

STEP 2 – HARDNESS: This display will show “–nA– (not available)” if “FILTER” is selected.

Press

NEXT to go to step 3. Press REGEN to exit.

STEP 3 – DAY OVERRIDE: The manufacturer has factory set 3 DAYS as the default.

This is the maximum number of days between regenerations. If this is set to “OFF”,

regeneration initiation is based solely on gallons used. If any number is set (allowable

range from 1 to 28), a regeneration initiation will be called for on that day even if a

sufficient number of gallons were not used to call for a regeneration.

Set Day Override using + or — buttons (3 is recommended):

• set number of days between regeneration (1 to 28); or

• set to “OFF”.

Press

NEXT to go to step 4. Press REGEN if you need to return to the previous step.

2. Programming:

1 2 3

PROGRAMMING PROCEDURES: