Troubleshooting guide

3. MANUAL REGENERATION: Sometimes there is a need to

regenerate before the control valve calls for it. This may be

needed if a period of heavy water use is anticipated or when

the system has been operated without salt.

• To initiate a manual regeneration at the next

preset regeneration time, press and release

REGEN. The words “REGEN TODAY” will flash

on the display to indicate that the system will

regenerate at the next regeneration time (set in

Programming, steps 4 and 5). If you pressed the

REGEN button in error, pressing the button again

will cancel the command.

• To initiate a manual regeneration immediately, press and hold

the

REGEN button for three seconds. The system will begin to

regenerate immediately. This command cannot be cancelled.

Once a manual regeneration is initiated, the unit will go into the BACKWASH position and subsequent

positions thereafter (see Start Up Instructions for regeneration sequence), the water filter will deliver water,

but it will be untreated.

4. POWER LOSS AND BATTERY REPLACEMENT:

The AC transformer comes with a 15 foot power cord and is

designed for use with the control valve; the transformer should

only be used in a dry location.

In the event of a power outage that is less than 24 hours, the

control valve will remember all settings and time of day. After 24

hours, the only item that needs to be reset is the time of day and

will be indicated by the time of day flashing. All other settings are

permanently stored in the nonvolatile memory.

If a power loss occurs that is less than 24 hours and the time of

day flashes, this indicates that the battery is depleted. The time of

day should be reset and the non-rechargeable battery should be

replaced. The battery is a 3 Volt Lithium Coin Cell type 2032 and

is readily available at most stores. To access battery location,

remove front cover (see diagram on page 14 for battery location).

5. ERROR MESSAGE: If the word “ERROR” and a number are

alternately flashing on the display record the number and

contact the dealer for help. This indicates that the control valve

was not able to function properly.

MANUAL REGENERATION

BATTERY REPLACEMENT

ERROR