Troubleshooting guide

1900 Prospect Court • Appleton, WI 54914
Phone: [phone] • Fax: [phone]
MANUAL
REGENERATION
NOTE: If you need
to initiate a manual
regeneration, either immediately, or the
same night at the preprogrammed time
for regeneration (typically 12:00 AM),
complete the following steps.
For Immediate Regeneration:
Press and hold regen until valve motor starts (typically 3 seconds).
For Regeneration the same night:
Press and release regen (notice that flashing “REGEN TODAY” appears).
ERROR
If the display toggles between “Error”
and an error code (i.e. a number),
call a service technician and report
the error code.
BYPASS VALVE OPERATION
To shut off water to the system, position arrow handles as shown in
the bypass operation diagram below. If your valve doesn’t look like
the diagram below, contact your service technician for instructions
on how to shut off water.
NORMAL OPERATION BYPASS OPERATION
ADJUST DAYS BETWEEN
REGENERATION OR TIME
OF REGENERATION
QUICK REFERENCE GUIDE:
GENERAL OPERATION
When the system is operating,
one of three displays will be
shown: time of day, gallons of
treated water available,
or gallons per minute.
Pressing next will
toggle between the
three choices.
TO SET TIME OF DAY
In the event of a
prolonged power
outage, time of day
flashes, indicating
that this needs to
be reset. All other
information will be
stored in memory
no matter how long
the power outage.
Please complete the
steps as shown
to the right. To
access this mode,
press set clock.
1. Accessed by
pressing set clock
2. Adjust hours with
+ and — buttons,
AM/PM toggles
at 12.
3. Press next
4. Adjust minutes with
+ and — buttons.
5. Press next to
complete and
return to normal
operation.
For initial setup or to make
adjustments, please complete the
steps as shown to the right.
1. Access by pressing next and +
button simultaneously.
2. Hardness display shows “-nA-”
when used as a filter.
3. Press next
4. Adjust days between regenerations
using + and — buttons.
5. Press next
6. Adjust time of regeneration hour
with + and — buttons, AM/PM
toggles at 12.
7. Press next
8. Adjust time of regeneration minutes
with + and — buttons.
9. Adjust backlight display function
with + and — buttons.
10. Press next to complete and return
to normal operation.
© 2014 Water-Right, Inc. All rights reserved.
LIT-IMF/IMPF Man ROPU 9/14 2M