Installation Guide

D) INSTALLATION CHECKOUT
1) Ensure all connections are tightened properly.
2) Turn on main water supply.
3) Turn on and off cold and hot water respectively.
4) Turn on both hot and cold water and turn off. Check for leaks.
5) Remove the aerator with attached key. Check for debris. Clean of necessary.
6) Reinstall aerator.
COMPLETE INSTALLATION
MODEL: F7-0001
C) DRAIN WASTE INSTALLATION
1) Disassemble the drain.
2) Apply plumbers’ putty or sealant to bottom side of flange.
(Or use attached rubber washer to instead of putty)
3) Insert drain body through sink.
4) Attach the gasket, Teflon washer and tighten the lock nut.
5) Apply Teflon tape to the drain pipe threads and screw with drain body
6) Remove excessive plumbers’ putty or sealant.