Installation Guide

A) FAUCET INSTALLATION

1) Set the faucet in place and insert the hoses into

hole of deck or lavatory.

2) Screw and tighten washer, lock nut onto the

shank and secure the faucet

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if necessary

TOOLS AND MATERIALS

MODEL: F7-0001

B) SUPPLY CONNECTION

1) Apply Teflon tape to faucet inlet shanks and

angle stop threads.

2) Connect hoses (not provided) to faucet inlets and

angle stops.

3) Tighten all connections.

*** VERY IMPORTANT ***

4) Flush out water for two minutes before connect

hose to faucet valve.

(This act to avoid debris trapped the flow regulator)

METAL WASHER

LAVATORY FAUCET INSTALLATION GUIDE

M12-146

Basin Wrench

Adjustable wrench

Teflon Tape

Pipe Wrench

Screwdriver

Flexible Water

Supply Line

Apply Teflon tape

LOCK NUT

PAGE 1
MODEL: F7-0001 TOOLS AND MATERIALS LAVATORY FAUCET INSTALLATION GUIDE Basin Wrench Adjustable wrench Teflon Tape BEFORE YOU BEGIN 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage. 3) Replace waste or supply tubing if necessary Pipe Wrench A) FAUCET INSTALLATION B) SUPPLY CONNECTION 1) Set the faucet in place and insert the hoses into hole of deck or lavatory.
PAGE 2
MODEL: F7-0001 C) DRAIN WASTE INSTALLATION D) INSTALLATION CHECKOUT 1) Disassemble the drain. 2) Apply plumbers’ putty or sealant to bottom side of flange. (Or use attached rubber washer to instead of putty) 3) Insert drain body through sink. 4) Attach the gasket, Teflon washer and tighten the lock nut. 5) Apply Teflon tape to the drain pipe threads and screw with drain body 6) Remove excessive plumbers’ putty or sealant. 1) Ensure all connections are tightened properly. 2) Turn on main water supply.