Use and Care Manual

Page 12 of 16
LIGHTING INSTRUCTIONS
1.
Turn the control knob to the “OFF” position.
2.
Fully open LP cylinder valve.
3.
Push in gas control knob and turn counterclockwise to “LOW”, press
4.
the Igniter button repeatedly to light the burner.
If ignition does not occur within a few seconds release the control to
HOW TO EXTINGUISH ?
•
Turn control knob clockwise to the “low” position; let the knob
pop up and continue turning the control knob to the “off” position.
• Wait 5 minutes after extinguishing flame prior to placing a lid (if
applicable) or protective cover on heating item.
•
Close the cylinder valve on the propane gas tank if you don’t intend
to use it for a long time.
Operation
Note: Improper operation, can cause injury or property damage. If burner
fails to remain lit, all valves should be closed and a waiting period of at
least 5 minutes should pass before attempting to light.
the “HIGH”, then release control knob. If you want a lower temperature,
push in the control knob and turn counterclockwise to the “LOW” (Figure c).
Be careful when attempting to manually ignite this fire pit. Holding in the
control knob for more than 10 seconds before igniting the gas will cause a
ball of flame upon ignition.