Specification

TECHNICAL DATA
WAT-07
WATCO
®
WIPE-ON POLY
Rust-Oleum Corporation Form: GDH-25
11 Hawthorn Parkway Phone: [phone] Rev.: 021413
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
,PHYSICAL PROPERTIES .
WIPE-ON POLY
Resin Type
Urethane-modified Alkyd
Pigment Type
NA
Solvents
Mineral spirits
Weight
Per Gallon
7.4 lbs.
Per Liter
0.88 kg
Solids
By Weight
48-50%
By Volume
42-44%
Volatile Organic Compounds
<460 g/l
Recommended Dry Film
Thickness (DFT) Per Coat
1.5-3.0 mils
Wet Film to Achieve DFT
(unthinned material)
3.5-6.5 mils
Theoretical Coverage at
1 mil DFT (25µ)
176 sq.ft./quart
Practical Coverage at Recommended
DFT (assumes 15% material loss)
50-100 sq.ft./quart (Varies with type and porosity of wood)
Dry Times at 77°F
(25°C) and 50%
Relative Humidity
Touch
2-4 hours
Handle
8-12 hours
Recoat
4-6 hours
Full Cure
24 hours
Shelf Life
3 years
Flash Point
>100°F (38°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.