Technical Specifications

TECHNICAL DATA
WAT-01
WATCO
®
LACQUER CLEAR WOOD FINISH
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDH-416
Rev.: 032718
PHYSICAL PROPERTIES
LACQUER CLEAR WOOD FINISH
Spray
Brush On
Resin Type
Nitrocellulose modified alkyd
Nitrocellulose modified alkyd, rosin
Pigment Type
None
None
Solvents
Acetone, Toluene, Glycol ethers, N-
Butanol, N-Butyl Acetate
Acetone, Toluene, Glycol ethers, N-
Butanol, N-Butyl Acetate
MIR
0.85 Max
NA
Fill Weight
11.5 oz.
NA
Weight
Per Gallon
NA
7.5 lbs.
Per Liter
NA
0.9 kg
Solids
By Weight
NA
25.8 - 29.1%
By Volume
NA
20.6 – 21.7%
Volatile Organic Compounds
NA
651 – 659 g/l
Recommended Dry Film
Thickness (DFT) per Coat
1.0 – 1.5 mils
1.0 – 1.5 mils
Wet Film to Achieve DFT
(unthinned material)
NA
5.0 – 7.0 mils
Practical Coverage at Recommended
DFT (assume 15% material loss)
40 sq.ft./can
190 – 290 sq.ft./gal.
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
30 minutes
1 hour
Recoat
2 hours
12 hours
Light Use
24 hours
24 hours
Normal Use
7 days
7 days
Flash Point
-156°F (104°C)
>93°F (34°C)
Shelf Life
3Years
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.