Specification

TECHNICAL DATA
WAT-16
WATCO
®
DANISH OIL FINISH (450 VOC)
Rust-Oleum Corporation Form: GDH-883
11 Hawthorn Parkway Phone: [phone] Rev.: 063015
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
,PHYSICAL PROPERTIES .
DANISH OIL FINISH
Resin Type
Raw Linseed Oil, Soybean Oil, Hydrocarbon Resin
Pigment Type
Varies with color
Solvents
Low Aromatic Mineral Spirits, Light Aromatic Naphtha
Weight
Per Gallon
7.0 lbs.
Per Liter
0.84 kg
Solids
By Weight
42.1-42.5%
By Volume
36.5-37.0%
Volatile Organic Compounds
<450 g/l (3.75 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-1.5 mils
(25-37.5µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
70-75 sq.ft./pint (1.7-1.8 m
2
/l)
Varies with type and porosity of wood
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Penetrate
30 minutes
Reapply
15 minutes
Light Use
8-10 hours
Topcoat
If polyurethane is desired, wait 72 hours
Shelf Life
3 years
Flash Point
104°F (40°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.