Technical Specifications

TECHNICAL DATA
WAT-04
WATCO
®
BUTCHER BLOCK OIL & FINISH
1
Form: GDH-638
Rev.: 012618
DESCRIPTION AND USES
Watco
®
Butcher Block Oil & Finish is specially formulated for
use on wooden butcher blocks, cutting boards and salad
bowls. Easy to apply and maintain, it is nontoxic and safe for
food contact when fully dried (meets government standards of
21 CFR 175.300). Butcher Block Oil & Finish provides a rich
lustrous sheen while protecting wood surfaces.
PRODUCTS
SKU
DESCRIPTION
241758
Pint
332152
Half Pint
PRODUCT APPLICATION
SURFACE PREPARATION
Prepare bare wood for finishing by sanding in the direction of
the grain. Begin with #150 grit sandpaper and progress
though #180 and #220 grits. Before applying oil, remove all
sanding dust and dirt with a vacuum.
PRODUCT APPLICATION (cont.)
APPLICATION
Watco Butcher Block Oil & Finish is a ready-to-use product.
Do not thin. Use only at room temperature. Mix material
thoroughly before application. Stir occasionally during use.
Apply with a soft, clean cloth. Allow 6 hours dry time before
re-coating. Prior to re-coating, lightly scuff sand with #400
grit sandpaper. Allow 72 hours prior to normal use. Hand
wash surface prior to contact with food. DO NOT WASH IN
DISHWASHER. If desired, use additional coats to build a
finish. Do not apply over other finishes. When used on
objects with small openings, such as canisters, proper drying
may be inhibited when applied on interior surface.
CLEAN UP
Application tools or brushes should be cleaned with mineral
spirits or paint thinner.