User guide

Installing the Firebox X Edge
24 WatchGuard Firebox X Edge
Running the Quick Setup Wizard
After you start your computer and type https://192.168.111.1 into
the URL entry field of your Internet browser, the Quick Setup Wizard
starts. You must use the wizard to configure the Ethernet interfaces.
You can change the configuration of the interfaces after you use the
wizard.
The Quick Setup Wizard includes this set of dialog boxes. You will
not see all of these dialog boxes because some only appear based on
the configuration method you select:
Welcome
The first screen tells you about the wizard.
Configure the External Interface of your Firebox
This screen sets the method your ISP uses to assign your IP
address.
Configure the External Interface for DHCP
On this screen, type in your DHCP identification as supplied by
your ISP.
Configure the External Interface for PPPoE
On this screen, type in your PPPoE information as supplied by
your ISP.
Configure the External Interface with a static IP address
On this screen, type in your static IP address information as
supplied by your ISP.
Configure the Trusted Interface of the Firebox
On this screen, type the IP address of the trusted interface.
Set the User Name and Passphrase
Use this screen to set the user name and passphrase for the
administrator account for the Edge.
Set the Wireless Region
(For wireless models only.) Type the country or region in which
the Firebox X Edge Wireless is being used. This cannot be
changed after it is set.
Set the Time Zone
Use this screen to set the time zone the Firebox X Edge is
operating in.