User guide

Installing and Configuring the MUVPN Client
User Guide 167
Installing and Configuring the MUVPN Client
NOTE
To install and configure the MUVPN client, you must have local
administrator rights on the remote computer.
Installing the MUVPN client
To install the MUVPN client:
1 No other IPSec VPN client software can be on the computer.
Remove any other IPSec VPN software from the user’s computer
before installing the WatchGuard® MUVPN software.
2 Copy the MUVPN installation file and the .wgx file to the
remote computer.
3 Double-click the MUVPN installation file to start the
InstallShield wizard.
4 Click Next.
If the InstallShield gives you a message about read-only files, click Yes to
continue the installation.
5 A welcome message appears. Click Next.
The Software License Agreement appears.
6 Click Yes to accept the license agreement.
The Setup Type window appears.
7 Select the type of installation. We recommend that you use the
Typical installation. Click Next.
8 On a Windows 2000 computer, the InstallShield looks for the
Windows 2000 L2TP component. If the component is installed,
the InstallShield does not install it again. Click OK to continue.
The Select Components window appears.
9 Do not change the default selections. Click Next.
The Start Copying Files window appears.
10 Click Next to install the files.
When the dni_vapmp file is installed, a command prompt window
appears. The command prompt can stay for more than one minute. This
is usual. After the file is installed, the command window closes and the
installation continues.
11 After the installation is complete, click Finish.