User guide

Enabling MUVPN for Edge Users
User Guide 155
Wireless Network” on page 176 for information about how to
make the wireless computers use MUVPN on the Edge’s wireless
network.
• If you want to use a Pocket PC to make a VPN connection to
the Edge, read the section “Tips for Configuring the Pocket PC”
on page 177.
• At the end of this chapter is a section with troubleshooting tips.
Enabling MUVPN for Edge Users
Before you configure the MUVPN client, you must configure
MUVPN client and user settings on the Firebox® X Edge.
Configuring MUVPN client settings
Some MUVPN client settings apply to all of the Edge’s MUVPN con-
nections. Select Firebox Users > Settings to configure these:
• To make the .wgx file read-only so that the user cannot change
the security policy, select the Make the MUVPN client security
policy read-only check box.
• Set how the virtual adapter operates on the client (Disabled,
Preferred, or Required). The remote MUVPN computers can use
a virtual adapter to get network settings, an IP address, and
WINS and DNS address assignments. You can set the virtual
adapter rule for your mobile users to:
Disabled
The mobile user does not use a virtual adapter to connect with
the MUVPN client. This is the default setting. With the virtual
adapter disabled, the MUVPN client is not assigned a WINS or
DNS address. Because of this, make sure the computer has
correct WINS and DNS addresses configured in the primary
network card settings. See the section “Preparing Remote
Computers for MUVPN” on page 159 for information on
entering WINS and DNS addresses in advanced TCP/IP settings of
the network card.