User guide

Configuring Global WebBlocker Settings
User Guide 119
To configure WebBlocker:
1 To connect to the System Status page, type https:// in the
browser address bar, and the IP address of the Edge trusted
interface.
The default URL is: https://192.168.111.1
2 From the navigation bar, select WebBlocker > Settings.
The WebBlocker Settings page appears.
3 Select the Enable WebBlocker check box.
4 Type a password in the Full Access Password field.
The full access password gives access to all Web sites until the password
expiration or until the browser is closed.
5 Type the same password again in the Confirm Password field.
6 Type a number, in minutes, in the Inactivity Timeout field.
The Inactivity Timeout shows the length of time the Full Access Password
is active if no Web browsing is done. If a user types the Full Access
Password and no HTTP traffic is done from that user’s computer for the
length of time set in the Inactivity Timeout, WebBlocker rules start
again.