User guide

Network Settings
64 Firebox X Edge e-Series
Change the Firebox IP addresses with the Network Setup
Wizard
The easiest method to change the network IP addresses of the Firebox X Edge e-Series is with the Network
Setup Wizard.
1. To connect to the System Status page, type
https:// in the browser address bar, followed by the IP
address of the Edge trusted interface.
The default URL is: https://192.168.111.1
2. From the navigation bar, click Wizards.
3. Adjacent to Setup the primary network interfaces of the Firebox X Edge, click Go.
4. Follow the instructions on the screens.
The Network Setup Wizard has these steps:
Welcome
The first screen describes the purpose of the wizard.
Configure the external interface of your Firebox
Select the procedure your ISP uses to set your IP address. For detailed information, see About
configuring external interfaces. You can choose one of these configurations:
DHCP: If your ISP uses DHCP, type the DHCP information that your ISP gave you. For more
information, see If your ISP uses DHCP
.
PPPoE: If your ISP uses PPPoE, type the PPPoE information that your ISP gave you. For more
information, see If your ISP uses PPPoE
.
Static IP: If your ISP uses static IP addresses, type the static IP address information your ISP gave you.
For more information, see If your ISP uses static addresses
.
Configure the trusted interface of the Firebox
On this screen, type the IP address of the trusted interface. For more information, see About
configuring the trusted network.
After you configure the trusted interface, the Network Setup Wizard is complete.