User guide

Installing and Configuring the MUVPN Client
User Guide 119
4 Type a unique name for the new connection.
If this will be a unique policy for a specific user, enter a unique name to
identify the policy. For example, you may want to include the name of
the user.
5 Select the Secure option.
This is the default setting.
6 Select the Only Connect Manually checkbox.
7 Select the IP Subnet option from the ID Type drop-down list.
The Remote Party Identity and Addressing fields are updated.
8 When you set the Subnet and Mask addresses, you define
whether or not an MUVPN user accesses the Internet through
the tunnel and therefore accesses the Internet through the
tunnel. The checkbox All traffic uses tunnel (0.0.0.0/0 IP
Subnet) as described in “Enabling MUVPN Access for a User
Account” on page 127 must be set accordingly when
configuring the MUVPN account in the Firebox X Edge setup. If
the settings between the client and the Firebox X Edge do not
match, the VPN connection will fail.
If you want to access only the trusted network through the
tunnel, type the trusted network address in both the Subnet
and Mask fields. The checkbox All traffic uses tunnel (0.0.0.0/
0 IP Subnet) must not be selected if the client will only send
traffic destined for the Firebox X Edge trusted network for
through the VPN connection.
If you want to access both the trusted network and the Internet,
type 0.0.0.0 in both the Subnet and Mask fields. The checkbox
All traffic uses tunnel (0.0.0.0/0 IP Subnet) must be selected if
all traffic will be sent from the MUVPN client through the VPN.