User guide

Installing and Configuring the MUVPN Client
User Guide 117
11 Click Cancel to close the connection window.
Installing and Configuring the MUVPN Client
The MUVPN installation files are available at the WatchGuard Web
site:
http://www.watchguard.com/support
NOTE
To install and configure the MUVPN client, you must have local
administrator rights on the remote computer.
Installing the MUVPN client
Follow these steps to install the MUVPN client:
1 Copy the MUVPN installation file to the remote computer.
2 Double-click the MUVPN installation file to start the
InstallShield wizard.
3 Click Next.
If the InstallShield stops because read-only files are detected, click Yes
to continue the installation.
4 A welcome message is displayed. Click Next.
The Software License Agreement is displayed.
5 Click Yes to accept the terms of the License Agreement.
The Setup Type window appears.
6 Select the type of installation. WatchGuard recommends that
you use the Typical installation. Click Next.
7 On a Windows 2000 computer, the InstallShield will detect the
Windows 2000 L2TP component. If the component is installed,
the InstallShield does not install it again. Click OK to continue.
The Select Components window appears.
8 Do not change the default selections. Click Next.
The Start Copying Files window appears.
9 Click Next to install the files.
When the dni_vapmp file is installed, a command prompt window
appears. This is normal. When the file has been installed, the command
prompt window will close and the process will continue.
10 When the InstallShield wizard is complete, click Finish.