User guide

Configuring the MUVPN Client
112 WatchGuard Firebox X Edge
modem is not available, you can select a serial cable between
two computers.
8 Select the modem added in the previous step from the Add RAS
Device window.
9 Click OK, click Continue and then click Close.
10 Reboot the computer.
Configuring the WINS and DNS settings
The remote computer must be able to communicate with the WINS
servers and the DNS servers. These servers are located on the trusted
network that is protected by the Firebox X Edge.
From the Windows desktop:
1 Select Start => Settings => Control Panel.
2 Double-click the Network icon.
The Network window appears.
3 Click the Protocols tab and then select the TCP/IP protocol.
4 Click Properties.
The Microsoft TCP/IP Properties window appears.
5 Click the DNS tab and then click Add.
6 Enter the IP address of your DNS server in the applicable field.
To add additional DNS servers, repeat steps 5 and 6.
NOTE
The DNS server on the private network behind the Firebox X Edge
must be the first server in the list.
7 Click the WINS Address tab, type the IP address of your WINS
server in the applicable field, and then click OK.
To add additional WINS servers, repeat this step.
8 Click Close to close the Network window.
The Network Settings Change dialog box appears.
9 Click Yes to restart the computer.
The computer reboots.
Windows 2000 setup
This section describes how to install and configure the network
components that are required for the Windows 2000 operating sys-
tem. These components must be installed before the MUVPN client
will function correctly on a Windows 2000 computer.