User guide

Working with Control Center
User Guide 73
• To issue a traceroute command to a source or destination IP address
of a deny message, right-click the message and select Source IP =>
Trace Route or Destination IP => Trace Route. (When you issue this
command, you are prompted to enter the configuration passphrase.)
Working with Control Center
The basic tasks you perform with Control Center are connecting to a
Firebox, changing the interval at which the Firebox is queried for status
information, and opening other Firebox System applications.
Running the QuickSetup Wizard
Normally, you will run the QuickSetup Wizard when you first install
your Firebox. However, you can run it from Control Center as well.
1 Click the Control Center Main Menu button (shown below right),
which is located on the upper-left corner of Control Center.
2 Select QuickSetup Wizard.
The QuickSetup Wizard begins. For more information on running
the QuickSetup Wizard, see the QuickStart Guide included with
your Firebox.
Opening Firebox System applications
To open Firebox System applications, click the Control Center Main Menu
button. Click Tools.
You can open any of the following applications from this menu:
Policy Manager
Firebox Monitors
LogViewer
HostWatch
Historical Reports
For more information on launching Firebox System applications, see
“Using Control Center Applications” on page 78.
You can also perform the following from this menu: