User guide

Adding Secondary Networks
User Guide 57
Adding Secondary Networks
Your configuration may require that you add secondary networks to any
of the Firebox interfaces. For more information on secondary networks,
see “Adding secondary networks to your configuration” on page 29.
1 Select Network => Configuration.
The Network Configuration dialog box appears.
2 Click the Secondary Networks tab.
The Secondary Networks tab appears, as shown in the following figure.
3 Use the drop list in the lower-right portion of the dialog box to select
the interface to which you want to add a secondary network.
4 Use the field in the lower-left portion of the dialog box to type an
unused IP address from the secondary network.
When typing IP addresses, type the digits and periods in sequence. Do not use the
TAB or arrow key to jump past the periods. For more information on entering IP
addresses, see “Entering IP addresses” on page 38.
N OTE
Check secondary network addresses carefully. Policy Manager does not
verify that you have entered the correct address. WatchGuard strongly
recommends that you do not enter a subnet on one interface that is part of
a larger network on another interface.