User guide

Setting IP Addresses of Firebox Interfaces
User Guide 53
Setting addresses in drop-in mode
If you are using drop-in mode, all interfaces use the same IP address:
1 Select Network => Configuration.
The Network Configuration dialog box appears, as shown in the following
figure.
2 Enable the checkbox marked Configure interfaces in Drop-In mode,
located at the bottom of the dialog box.
3 Enter the IP address and default gateway for the Firebox interfaces.
When typing IP addresses, type the digits and periods in sequence. Do not use
the TAB or arrow key to jump past the periods.
For more information on
entering IP addresses, see “Entering IP addresses” on page 38.
If you are using static PPPoE on your External interface, you also need to enter
your PPP user name and password. For more information on PPPoE support, see
“Dynamic IP support on the External interface” on page 31.
4 Select the method for obtaining an IP address: Static, DHCP, or
PPPoE.